10 inch tablet stand, 62 degrees (desk)
A ribbon stand, rippled with waves for a 10 inch tablet at 62 degrees, the all-round desk angle. It is one 5 mm band folded into lip, floor, leaning support, back leg and foot, so it takes a fraction of the plastic of a solid block. The cradle is cut for a 9 mm device so it sits snug without scratching, and it opens up by the pattern's depth so the device rests on the crests. It prints lying on its side exactly as exported, so the layers run across the load and nothing overhangs. Measure your device with its case and adjust in the configurator.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Device | 10 inch tablet, 9 mm thick including the case |
|---|---|
| Angle | 62 degrees, the all-round desk angle |
| Shape | Ribbon: one 5 mm band folded into lip, floor, leaning support, back leg and foot |
| Pattern | waves, 2.5 mm deep every 16 mm |
| Cradle | 140 mm wide, 16 mm front lip |
| Back support | 90 mm tall |
Printing
- Prints lying on its side exactly as exported: no supports; patterns lean 45 degrees at most.
- Ribbon and arch: print the band solid or with 4+ walls. Frame and solid: 3 walls, 15% infill.
- Steep angles are for watching; about 50 degrees is the typing sweet spot.
More phone & tablet stands
- Phone charging stand for an 11 mm case
- Tablet stand 10-11 inch
- Phone with a case stand, 50 degrees (typing)
- Phone with a case stand, 62 degrees (desk)
- Phone with a case stand, 72 degrees (video)
- Phone without a case stand, 50 degrees (typing)
- Phone without a case stand, 62 degrees (desk)
- Phone without a case stand, 72 degrees (video)
- All phone & tablet stands · set your own dimensions in the Phone & Tablet Stand Generator