Phone without a case stand, 50 degrees (typing)
A arch stand, cut into uneven facets for a phone without a case at 50 degrees, a shallow angle for tapping and typing. It is one 4 mm band whose support curls over the top and comes down behind in a single curve, so it takes a fraction of the plastic of a solid block. The cradle is cut for a 8 mm device so it sits snug without scratching, and it opens up by the pattern's depth so the device rests on the crests. It prints lying on its side exactly as exported, so the layers run across the load and nothing overhangs. Measure your device with its case and adjust in the configurator.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Device | phone without a case, 8 mm thick including the case |
|---|---|
| Angle | 50 degrees, a shallow angle for tapping and typing |
| Shape | Arch: one 4 mm band whose support curls over the top and comes down behind in a single curve |
| Pattern | facets, 2.5 mm deep every 12 mm |
| Cradle | 72 mm wide, 12 mm front lip |
| Back support | 50 mm tall |
Printing
- Prints lying on its side exactly as exported: no supports; patterns lean 45 degrees at most.
- Ribbon and arch: print the band solid or with 4+ walls. Frame and solid: 3 walls, 15% infill.
- Steep angles are for watching; about 50 degrees is the typing sweet spot.
More phone & tablet stands
- Phone charging stand for an 11 mm case
- Tablet stand 10-11 inch
- Phone with a case stand, 50 degrees (typing)
- Phone with a case stand, 62 degrees (desk)
- Phone with a case stand, 72 degrees (video)
- Phone without a case stand, 62 degrees (desk)
- Phone without a case stand, 72 degrees (video)
- Phone without a case charging stand, 62 degrees
- All phone & tablet stands · set your own dimensions in the Phone & Tablet Stand Generator