Phone with a thick case charging stand, 62 degrees
A charging stand for a phone with a thick case. The cradle at the front is raised and touches nothing below it: a leg runs down and back from the top of the support to a base that reaches forward under the cradle. A 14 mm slot through the middle of the cradle floor and lip is open to the front, so you slide the cable in, plug in and set the device down, and the plug hangs in the air. It prints lying on its side exactly as exported, no supports. Use an angled cable if your plug and its bend are longer than about 25 mm.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Device | phone with a thick case, 14 mm thick including the case |
|---|---|
| Angle | 62 degrees, the all-round desk angle |
| Shape | Ribbon, raised: a 5 mm band with the cradle up on a base |
| Charging | 14 mm slot through the cradle floor and lip, open to the front |
| Raised | 40 mm above the desk, 8 mm lip |
| Back support | 58 mm tall |
Printing
- Prints lying on its side exactly as exported: no supports; patterns lean 45 degrees at most.
- Ribbon and arch: print the band solid or with 4+ walls. Frame and solid: 3 walls, 15% infill.
- Steep angles are for watching; about 50 degrees is the typing sweet spot.
More phone & tablet stands
- Phone charging stand for an 11 mm case
- Tablet stand 10-11 inch
- Phone with a case stand, 50 degrees (typing)
- Phone with a case stand, 62 degrees (desk)
- Phone with a case stand, 72 degrees (video)
- Phone without a case stand, 50 degrees (typing)
- Phone without a case stand, 62 degrees (desk)
- Phone without a case stand, 72 degrees (video)
- All phone & tablet stands · set your own dimensions in the Phone & Tablet Stand Generator