Project box 60 x 40 x 25 mm, snap lid
A plain project box for a sensor, a relay module or a tiny MCU board: a 60 x 40 x 25 mm cavity with a snap lid and 2.4 mm walls that do not flex when a plug goes in. Open the configurator to cut connector openings from the library (USB-C, barrel jack, RJ45, switches and more) exactly where your board needs them.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Inside | 60 x 40 x 25 mm |
|---|---|
| Lid | snap-on plug skirt |
| Wall | 2.4 mm |
| Cutouts | none; add USB, jack, switch or custom openings in the configurator |
| Feet | yes |
Printing
- Base prints open side up, lid prints upside down; no supports.
- Walls are 2.4 mm so a plug pushed into a port does not flex the case.
- Snap lid: 0.35 mm bead, pops on and off with a fingernail; screw lid takes M3 self-tappers.
More electronics enclosures
- Raspberry Pi 5 case, snap-on lid
- Raspberry Pi 5 case, vented, snap lid
- Raspberry Pi 5 case, screw lid
- Raspberry Pi 4B case, snap-on lid
- Raspberry Pi 4B case, vented, snap lid
- Raspberry Pi 4B case, screw lid
- Raspberry Pi 3B+ case, snap-on lid
- Raspberry Pi 3B+ case, vented, snap lid
- All electronics enclosures · set your own dimensions in the Electronics Enclosure Generator