Raspberry Pi 5 case, vented, snap lid
An enclosure for the Pi 5: USB-C power, two micro-HDMI, Ethernet, four USB and the microSD slot all open in the walls. The board sits on standoffs on its mounting holes, 85 x 56 mm, inside a 92.0 x 64.0 x 30.0 mm cavity with slot vents in the lid and side walls for a board that runs warm. Base prints open side up and the lid upside down; nothing needs supports.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Board | Raspberry Pi 5 |
|---|---|
| Cavity | 92.0 x 64.0 x 30.0 mm inside |
| Lid | snap-on, 4 mm skirt with a 0.35 mm bead |
| Ports | 7 openings cut to the board's connectors |
| Vents | top, left, right walls, 3 mm slots |
| Wall | 2.4 mm |
| Feet | yes |
Printing
- Base prints open side up, lid prints upside down; no supports.
- Walls are 2.4 mm so a plug pushed into a port does not flex the case.
- Snap lid: 0.35 mm bead, pops on and off with a fingernail; screw lid takes M3 self-tappers.
More electronics enclosures
- Raspberry Pi 5 case, snap-on lid
- Raspberry Pi 5 case, screw lid
- Raspberry Pi 4B case, snap-on lid
- Raspberry Pi 4B case, vented, snap lid
- Raspberry Pi 4B case, screw lid
- Raspberry Pi 3B+ case, snap-on lid
- Raspberry Pi 3B+ case, vented, snap lid
- Raspberry Pi 3B+ case, screw lid
- All electronics enclosures · set your own dimensions in the Electronics Enclosure Generator