Sink drain hair catcher, 32 mm
A basket for the small drain of a bathroom sink. The flange has a 45° seat underneath, so it rests on the edge of the hole and centres itself, and the same slope lets it print without supports. Side slots in the wall keep water moving when the floor fills with hair.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Fits | 32 mm drain hole |
|---|---|
| Basket | ⌀40 flange, 15 mm deep |
| Openings | 1.5 mm radial slots and side slots |
| Handle | centre knob |
| Material | PETG or TPU |
Printing
- Prints as exported with no supports: baskets bottom down, covers flat side down.
- PETG or TPU. PLA softens in hot water.
- Not sure about the hole size? Print the fit-test ring first, it takes a few minutes.