Hair catcher for a pop-up stopper sink, 38 mm
For a sink whose drain has a pop-up stopper. Take the stopper out, drop the basket in, and push the stopper back through the 8 mm hole in the middle. The ear sits on the flange because a knob in the middle would block the stem. If your stem is thicker, open the configurator and change the hole.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Fits | 38 mm drain hole with a pop-up stopper |
|---|---|
| Stopper hole | ⌀8 mm |
| Openings | 1.5 mm round holes and side slots |
| Handle | ear on the flange |
| Material | PETG or TPU |
Printing
- Prints as exported with no supports: baskets bottom down, covers flat side down.
- PETG or TPU. PLA softens in hot water.
- Not sure about the hole size? Print the fit-test ring first, it takes a few minutes.