Mini windowsill planter 120 mm
A trough for one succulent or a cutting: 120 mm long, 70 mm wide and 60 mm tall, holding about 0.3 litres of soil. The drip tray has internal ribs so the pot sits above its puddle. Vertical flutes catch the light; PETG resists wet soil for years, PLA lasts a season or two.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Trough | 120 x 70 x 60 mm, walls lean out 6 mm at the rim |
|---|---|
| Walls | fluted, 2.8 mm |
| Soil | about 0.3 L with 2 cm headroom |
| Drainage | holes in the floor |
| Tray | ribbed drip tray, 16 mm lip |
Printing
- Both parts print upright without supports: the taper leans only a few mm over the wall height.
- 3 walls, any infill; PETG resists wet soil, PLA lasts a season or two.
- Cover the drainage holes with a shard or mesh so soil stays in.
More windowsill planters
- Fluted herb trough 200 mm
- Big windowsill trough 250 mm
- Succulent bar 160 mm
- Windowsill planter 180 mm, fluted
- Windowsill planter 200 mm, plain
- Windowsill planter 220 mm, fluted
- Deep windowsill planter 250 mm
- Windowsill planter 280 mm
- All windowsill planters · set your own dimensions in the Planter Generator