Two-cell bench tray 200 x 100 mm
A sorting tray for a left/right keep-or-scrap tray: 2 by 1 cells in a 200 x 100 mm footprint, 25 mm tall. Each cell has a 10 mm scoop on its front edge so small parts roll into your fingers. The stacking foot drops into the rim of the tray below, so a stack stays put on a shelf.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Size | 200 x 100 x 25 mm |
|---|---|
| Cells | 2 x 1 = 2, each about 96 x 94 mm |
| Scoop | 10 mm cove on every cell front |
| Stacking | stepped foot seats in the rim below |
| Walls | 3 mm outer, 1.6 mm dividers |
Printing
- Prints flat, no supports; the block under the floor is infill, not plastic.
- PETG slides parts nicely; PLA is stiffer.
- The stacking foot has a 45 degree flare that seats on the rim below and prints support-free.
More parts & sorting trays
- Screw sorter tray 4 x 3, stackable
- Bead tray 6 x 4, shallow
- Small parts tray 120 x 90 mm, 6 cells
- Screw sorter tray 160 x 120 mm, 12 cells, stackable
- Parts tray 200 x 150 mm, 20 cells, stackable
- Electronics parts tray 240 x 160 mm, 24 cells
- Bench tray 180 x 120 mm, 6 deep scooped cells
- Drill bit and driver tray 220 x 160 mm, 8 long slots
- All parts & sorting trays · set your own dimensions in the Parts Tray Generator