Desk edge cable clip, 3 cables
A desk-edge clamp with 3 rings for three cables held at the desk edge, no screws. The bore is the cable diameter plus 0.4 mm, so a 6 mm cable clicks in and stays; it squeezes a 25 mm desk top with a 0.3 mm interference and nubs, no screws. Print it in PETG if the cable goes in and out every day.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Style | desk-edge clamp with 3 rings |
|---|---|
| Cable | 6 mm outer diameter (bore 6.4 mm) |
| Mount | clamps a 25 mm desk edge, no screws |
| Wall | 2.4 mm |
| Length | 10 mm along the cable |
Printing
- Prints flat on the profile, no supports; the snap flexes inside the layer plane.
- PETG survives daily re-snapping, PLA is fine for set-and-forget.
- Screw mounts take 3.5 mm pan-head screws; tape mounts have a flat base.
More cable clips
- Screw-down cable saddle, 6 mm
- Desk cable comb, 4 channels
- Snap cable clip for 4 mm cables, adhesive
- Snap cable clip for 6 mm cables, adhesive
- Snap cable clip for 8 mm cables, screw mount
- Snap cable clip for 10 mm cables, screw mount
- Cable saddle clamp for 5 mm cables
- Cable saddle clamp for 8 mm cables
- All cable clips · set your own dimensions in the Cable Clip Generator