Snap clip for 3 mm cables, adhesive
A snap C-clip for earphone leads and thin sensor wires. The bore is the cable diameter plus 0.4 mm, so a 3 mm cable clicks in and stays; the flat base takes a square of double-sided tape. Print it in PETG if the cable goes in and out every day.
2D preview
Customize (configurator with these values)
Files are generated on request from the live generator; free, no account.
Specifications
| Style | snap C-clip |
|---|---|
| Cable | 3 mm outer diameter (bore 3.4 mm) |
| Mount | flat base for double-sided tape |
| Wall | 2.4 mm |
| Length | 10 mm along the cable |
Printing
- Prints flat on the profile, no supports; the snap flexes inside the layer plane.
- PETG survives daily re-snapping, PLA is fine for set-and-forget.
- Screw mounts take 3.5 mm pan-head screws; tape mounts have a flat base.
More cable clips
- Screw-down cable saddle, 6 mm
- Desk cable comb, 4 channels
- Snap cable clip for 4 mm cables, adhesive
- Snap cable clip for 6 mm cables, adhesive
- Snap cable clip for 8 mm cables, screw mount
- Snap cable clip for 10 mm cables, screw mount
- Cable saddle clamp for 5 mm cables
- Cable saddle clamp for 8 mm cables
- All cable clips · set your own dimensions in the Cable Clip Generator