WINDOWSILL PLANTER — print notes
====================================================

  Trough     250 × 100 × 110 mm · plain
  Soil       ~2.2 L
  Extras     drain holes + drip tray

  PRINTING
    Both parts upright, AS EXPORTED, no supports. 3 walls;
    PETG for anything that gets watered — PLA softens in a
    sunny window and lasts a season.

  Parts
    planter    250.0 ×  100.0 × 110.0 mm   #b5651d
    tray       253.8 ×  103.8 ×  16.0 mm   #3a3f47

  Notes
    ! Holds about 2.2 L of soil with 2 cm of headroom for watering.
    ! Both parts print upright, no supports — the taper leans only 6 mm over 110 mm of wall. 3 walls, any infill; PETG laughs at wet soil, PLA lasts a season or two.
    ! Drainage holes are in the floor — put a shard or mesh scrap over them so soil stays in.
    ! The tray's ribs hold the pot above the puddle — roots hate sitting in water even more than drought.

