PHONE / TABLET STAND — print notes
====================================================

  Device     up to 14 mm thick, leaning 60°
  Stand      94.6 deep × 120 wide × 96 tall

  PRINTING
    Print it EXACTLY as exported — lying on its side. In that
    orientation nothing overhangs, no supports are needed, and
    the layers run across the load instead of splitting under it.
    3 walls and 15% infill is plenty; PETG if it will sit in a car.

  Parts
    stand      94.6 ×   96.0 × 120.0 mm   #6aa5a0

  Notes
    ! Cradle takes a device up to 14 mm thick (with the case), leaning at 60°.
    ! Prints LYING ON ITS SIDE, exactly as exported — no supports, no overhangs at any angle, and the layers run across the load.
    ! Footprint 94.6 × 120 mm, 96 mm tall.
    ! A 14 mm channel runs under the device, so a charging cable plugs in while it stands.

