PARTS TRAY — print notes
====================================================

  Tray       160 × 120 × 30 mm
  Cells      4 × 3 · 37 × 36 mm inside
  Scoop      8 mm cove
  Stacking   yes — foot into rim rebate

  PRINTING
    Flat, AS EXPORTED, no supports. 3 walls, 10-15% infill
    (the body is mostly infill). PETG or PLA.

  Parts
    tray      160.0 ×  120.0 ×  33.8 mm   #d09540

  Notes
    ! 12 compartments (smallest 37 × 36 mm) inside. Prints flat, no supports; the block under the floor is infill, not plastic.
    ! PETG slides parts nicely; PLA is fine and stiffer.
    ! The 8 mm cove on each cell's front edge is the scoop — tip the tray slightly and roll parts out with a fingertip.
    ! Stackable: the foot drops 2.5 mm into the rim rebate below and its 45° flare seats on the rebate lip — self-centering, and the flare prints support-free where the old flat step needed help.

