PHONE / TABLET STAND — print notes
====================================================

  Device     up to 11 mm thick, leaning 62°
  Stand      64 deep × 78 wide × 61 tall

  PRINTING
    Print it EXACTLY as exported — lying on its side. In that
    orientation nothing overhangs, no supports are needed, and
    the layers run across the load instead of splitting under it.
    3 walls and 15% infill is plenty; PETG if it will sit in a car.

  Parts
    stand      64.0 ×   61.0 ×  78.0 mm   #6aa5a0

  Notes
    ! Cradle takes a device up to 11 mm thick (with the case), leaning at 62°.
    ! Prints LYING ON ITS SIDE, exactly as exported — no supports, no overhangs at any angle, and the layers run across the load.
    ! Footprint 64 × 78 mm, 61 mm tall.
    ! A 14 mm channel runs under the device, so a charging cable plugs in while it stands.

