PEGBOARD ACCESSORY — print notes
====================================================

  Board      US pegboard 1/4" (6.35 mm)
  Style      rack · 3 connectors
  Plate      120 × 40 mm

  PRINTING
    AS EXPORTED — face down, connectors pointing up. Their
    45-degree chamfers print with NO supports. PETG or PLA,
    3 walls, 0.2 mm layers.
    Mount: tilt the top in and hook the pegs, then swing
    down flat — like a metal pegboard hook.

  Parts
    rack       120.0 ×   40.0 ×  47.4 mm   #4a8fd4

  Notes
    ! Prints FACE DOWN as exported — connectors point up, their 45° chamfers need NO supports. PETG or PLA, 3 walls.
    ! Mounting: tilt the top edge toward the board, hook the pegs in, swing down — like any metal hook.
    ! The back plate prints as a bridge between the side panels — anchored both ends, any printer does it.
    ! Bar holes fit shafts, not handles — measure the shaft, add 1 mm. They print as horizontal bores; ream with a drill bit if a tight one matters.

