WINDOWSILL PLANTER — print notes
====================================================

  Trough     200 × 90 × 90 mm · fluted
  Soil       ~1.2 L
  Extras     drain holes + drip tray

  PRINTING
    Both parts upright, AS EXPORTED, no supports. 3 walls;
    PETG for anything that gets watered — PLA softens in a
    sunny window and lasts a season.

  Parts
    planter    201.6 ×   91.6 ×  90.0 mm   #b5651d
    tray       203.8 ×   93.8 ×  16.0 mm   #3a3f47

  Notes
    ! Holds about 1.2 L of soil with 2 cm of headroom for watering.
    ! Both parts print upright, no supports — the taper leans only 6 mm over 90 mm of wall. 3 walls, any infill; PETG laughs at wet soil, PLA lasts a season or two.
    ! Drainage holes are in the floor — put a shard or mesh scrap over them so soil stays in.
    ! The tray's ribs hold the pot above the puddle — roots hate sitting in water even more than drought.

