GRIDFINITY — print notes
====================================================

  Bin        1 × 1 units, 6u tall
  Features   lip: yes · magnets: yes · scoop: yes · label: no

  PRINTING
    Flat as exported, no supports — every chamfer is 45°.
    2 perimeters, 15% infill. Any material; PLA is fine indoors.
    Magnets: press ⌀6 × 2 mm into the pockets underneath after
    printing (pockets are ⌀6.5 × 2.4); a dot of CA glue holds.

  THE STANDARD
    42 mm pitch, 7 mm height units, the 0.8/1.8/2.15 foot profile —
    mates with every Gridfinity plate and bin out there.

  Parts
    bin          41.5 ×   41.5 ×  46.4 mm     17.1 cm³

  Warnings
    ! Standard Gridfinity: 42 mm pitch, 7 mm height units — mates with every baseplate and bin out there.
    ! Prints feet-down, no supports — the 45° foot and lip chamfers are self-supporting. 2 perimeters, 15% infill is plenty.
    ! Magnet pockets: ⌀6.5 × 2.4 mm, press-fit from below after printing; a drop of CA glue holds them.

