DRAWER ORGANIZER — print notes
====================================================

  Drawer     400 × 300 mm inside, 50 mm tall
  Organizer  399.2 × 299.2 mm (0.8 mm slack)
  Grid       5 × 3 = 15 cells
  Tiles      2 × 2

  CELLS (inner sizes, left->right, front->back)
    cell  1: 78.6 × 98.1 mm
    cell  2: 78.6 × 97.5 mm
    cell  3: 78.6 × 98.1 mm
    cell  4: 78 × 98.1 mm
    cell  5: 78 × 97.5 mm
    cell  6: 78 × 98.1 mm
    cell  7: 78 × 98.1 mm
    cell  8: 78 × 97.5 mm
    cell  9: 78 × 98.1 mm
    cell 10: 78 × 98.1 mm
    cell 11: 78 × 97.5 mm
    cell 12: 78 × 98.1 mm
    cell 13: 78.6 × 98.1 mm
    cell 14: 78.6 × 97.5 mm
    cell 15: 78.6 × 98.1 mm

  PRINTING
    Flat on the bed as exported. No supports anywhere.
    0.2 mm layers, 2 perimeters, 10–15% infill is plenty — the
    geometry is all walls anyway. PETG slides nicer than PLA.
    4 tiles print separately and butt together in the
    drawer — the drawer itself holds them in line.

  Parts
    tile-1    199.4 ×  149.4 ×  50.0 mm    125.3 cm³
    tile-2    199.4 ×  149.4 ×  50.0 mm    125.3 cm³
    tile-3    199.4 ×  149.4 ×  50.0 mm    125.3 cm³
    tile-4    199.4 ×  149.4 ×  50.0 mm    125.3 cm³

  Warnings
    ! The organizer is bigger than your 250 mm bed, so it splits into 2×2 tiles that print separately and butt together in the drawer. Grid lines carry across the joints.

