DRAWER ORGANIZER — print notes
====================================================

  Drawer     300 × 220 mm inside, 40 mm tall
  Organizer  299.2 × 219.2 mm (0.8 mm slack)
  Grid       2 × 3 = 6 cells
  Tiles      2 × 1

  CELLS (inner sizes, left->right, front->back)
    cell  1: 196.7 × 71.4 mm
    cell  2: 196.7 × 70.8 mm
    cell  3: 196.7 × 71.4 mm
    cell  4: 98.1 × 71.4 mm
    cell  5: 98.1 × 70.8 mm
    cell  6: 98.1 × 71.4 mm

  PRINTING
    Flat on the bed as exported. No supports anywhere.
    0.2 mm layers, 2 perimeters, 10–15% infill is plenty — the
    geometry is all walls anyway. PETG slides nicer than PLA.
    2 tiles print separately and butt together in the
    drawer — the drawer itself holds them in line.

  Parts
    tile-1    149.4 ×  219.2 ×  40.0 mm    108.3 cm³
    tile-2    149.4 ×  219.2 ×  40.0 mm    116.4 cm³

  Warnings
    ! The organizer is bigger than your 250 mm bed, so it splits into 2×1 tiles that print separately and butt together in the drawer. Grid lines carry across the joints.

