DRAWER ORGANIZER — print notes
====================================================

  Drawer     380 × 285 mm inside, 45 mm tall
  Organizer  379.2 × 284.2 mm (0.8 mm slack)
  Grid       4 × 2 = 8 cells
  Tiles      2 × 2

  CELLS (inner sizes, left->right, front->back)
    cell  1: 93.4 × 210.1 mm
    cell  2: 93.4 × 69.7 mm
    cell  3: 92.8 × 210.1 mm
    cell  4: 92.8 × 69.7 mm
    cell  5: 92.8 × 210.1 mm
    cell  6: 92.8 × 69.7 mm
    cell  7: 93.4 × 210.1 mm
    cell  8: 93.4 × 69.7 mm

  PRINTING
    Flat on the bed as exported. No supports anywhere.
    0.2 mm layers, 2 perimeters, 10–15% infill is plenty — the
    geometry is all walls anyway. PETG slides nicer than PLA.
    4 tiles print separately and butt together in the
    drawer — the drawer itself holds them in line.

  Parts
    tile-1    189.4 ×  141.9 ×  45.0 mm     94.5 cm³
    tile-2    189.4 ×  141.9 ×  45.0 mm     94.5 cm³
    tile-3    189.4 ×  141.9 ×  45.0 mm    102.4 cm³
    tile-4    189.4 ×  141.9 ×  45.0 mm    102.4 cm³

  Warnings
    ! The organizer is bigger than your 250 mm bed, so it splits into 2×2 tiles that print separately and butt together in the drawer. Grid lines carry across the joints.

