TCG DECK BOX — print notes
====================================================

  Deck       100 cards · double sleeves
  Inner      69.2 × 83.5 × 103.0 mm
  Lid        magnet

  PRINTING
    Both parts AS EXPORTED (box standing, lid/cap opening up)
    — no supports. 3 walls, ~10% infill. PETG shrugs off
    backpacks; PLA is fine on a shelf.
    Glue 4 × ⌀5×2 magnets (2 box
    rim, 2 cap ceiling). Dry-fit and CHECK POLARITY first.

  Parts
    box          80.1 ×   94.4 × 107.6 mm   #7a4fd4
    cap          80.1 ×   94.4 ×  15.4 mm   #2b2f38

  Notes
    ! Sized for 100 cards at 0.8 mm each (double sleeves) plus 3.5 mm of finger room — a full deck slides out, not falls out.
    ! Both parts print standing, no supports. 3 walls, 10% infill — the box is all perimeter anyway.
    ! Glue four ⌀5 × 2 mm magnets into the pockets (two in the box rim, two in the cap ceiling). CHECK POLARITY twice, glue once.

