WALL HOOK — print notes
====================================================

  Type       J hook
  Plate      26 × 68 × 6 mm (rounded)
  Arm        reach 42 mm, 9 mm thick, 14 mm wide
  Fillet     5 mm at the wall junction

  MOUNTING
    hole 1: plain       x=+0  y=57 mm from the bottom edge
    hole 2: plain       x=+0  y=11 mm from the bottom edge
    screws:  4 mm shank clearance

  PRINTING — the file is already oriented for it
    Print AS-IS: the hook lies on its SIDE, profile flat on
    the bed. No supports for any shape — and the layers run
    along the arm, which is the strongest direction (the load
    never peels layers apart).
    The screw holes print sideways; at 4 mm they bridge fine.
    4+ perimeters, 40%+ infill. PETG or ABS for anything that carries
    weight; PLA is fine for keys, cables and light coats.

  Parts
    hook      42.5 ×  68.0 ×  14.0 mm     12.0 cm³   #2f3a45

  Warnings
    ! Prints lying on its SIDE, as oriented in the file: the profile sits flat on the bed, so NO supports for any curl — and the layers run along the arm, the strongest direction. 4+ walls, 40%+ infill; PETG/ABS for load, PLA for keys and coats.

