VASE / PLANTER — print notes
====================================================

  Size        ⌀55 (bottom) → ⌀28 (top) × 140 mm
  Profile     gaussian, belly ×1.55 at 42%

  SLICER SETUP — VASE MODE (this file is built for it)
    1. Enable spiral / vase mode
       Bambu/Orca: Others -> Special mode -> Spiral vase
       PrusaSlicer: Print settings -> Layers -> Spiral vase
    2. Bottom layers: 3  (= 0.6 mm solid floor)
    3. Line width 0.6–0.8 mm with a 0.4 nozzle — a fatter single
       wall is the whole difference between a vase and a leaky lamp
    4. To hold water reliably: 2–3 % flow bonus, or accept that
       PLA + tall + thin may seep and print PETG instead

    The model is a FULL solid on purpose. Vase mode uses only its
    outer contour; do not hollow it, do not add a modifier.

  Parts
    vase       69.7 ×   69.7 ×  140.0 mm     354.7 cm³   #7a8ba6

